CUH SDVC31 Series - Logical Relation Setting of the Switch Sensor

CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
21
SDVC31 Series
Variable Frequency Digital Controller for Vibratory Feeder
SDVC31SMSEN_4.012023-08
Under normal circumstances, the controller receives no signal from the Switch
Sensor and runs by default. But in some special applications the controller
needs to be stopped when receives no signal from the Switch Sensor. Adjusting
this parameter can fulfill this kind of application.
5.3.3 Logical Relation Setting of the Switch Sensor
Variable Frequency Digital Controller
for Vibr
atory Feeder
Variable Frequency Digital Controller
for Vibratory Feeder
Saturated
Saturated
Accelerate
Accelerate
Remote
Remote
Stop
Stop
Lock
Lock
Voltage
Voltage
Frequency
Frequency
On Delay
On Delay
Off Delay
Off Delay
Soft Start
Soft Start
SDVC31-M
SDVC31-M
8Long press and ▲
simultaneously to enter the
advanced parameter interface.
8Short press to switch to
Parameter Γ2.
8Press ▲ or ▼ to adjust the
parameter value.
Normal Close
Normal Open
Parameter Γ2 is set to ___ by default.
lWhen Parameter Γ2 is set to___, namely no signal received, the controller runs.
lWhen Parameter Γ2 is set to_-_, namely no signal received, the controller stops.