CUH SDVC31 Series - Logical Relation Setting of the Controlling Output

CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
24
5.5.2 Logical Relation Setting of the Controlling Output
SDVC31 Series
Variable Frequency Digital Controller for Vibratory Feeder
SDVC31SMSEN_4.012023-08
Variable Frequency Digital Controller
for Vibr
atory Feeder
Variable Frequency Digital Controller
for Vibratory Feeder
Saturated
Saturated
Accelerate
Accelerate
Remote
Remote
Stop
Stop
Lock
Lock
Voltage
Voltage
Frequency
Frequency
On Delay
On Delay
Off Delay
Off Delay
Soft Start
Soft Start
SDVC31-M
SDVC31-M
8Long press and ▲
simultaneously to enter the
advanced parameter interface.
8Short press to switch to
Parameter Γ3.
8Press ▲ or ▼ to adjust the
parameter value.
Normal Close
Normal Open
Parameter Γ3 is set to ___ by default.
lWhen Parameter Γ3 is set to___, the controlling output works as the controller
runs.
When Parameter Γ3 is set to_-_, l the controlling output doesn't works as the
controller runs.