Page 11 - Revision:EU-2020-10-13
SERVICE REQUIREMENTS
WARNING! Read and understand the contents of this manual before attempting to service
C100 Water Treatment System. Failure to follow the instructions in this manual could
result in death, serious personal injury, or severe property damage. Only trained and
qualified technicians should attempt to install, maintain, or service Culligan Equipment.
1. Visually inspect all electrical and water connections for signs of wear or damage.
DANGER! HIGH VOLTAGE ELECTRICAL HAZARD. Unplug before inspection and service.
2. Ensure there is adequate (minimum of 50 cm) clearance around the unit and clean the Condenser
Grill and Compressor fan to provide efficient cooling system operation.
3. Sanitize the Cold Tank per instructions in the pre-installation procedures.
4. Clean and sanitize external surfaces of the unit. Use only chemicals that are compatible with ABS
plastic and will not damage or degrade the product surfaces.
5. Remove and clean the Faucet. Replace as needed.
WARNING! SANITIZER MAY CONTAIN HAZARDOUS CHEMICALS. Use of proper personal
protective equipment such as rubber gloves and eye protection is required.
To Next Page
Loading...
