Safety Information 5
Cat. No. 01023621
Electrical Safety
• Only connect the power cord to a 120V, 15A (GFI preferred) properly grounded outlet.
• Never pull the power plug from the outlet with a wet hand or allow the plug to get wet.
• Keep the power cord out of heavy traffic areas. To avoid a fire hazard, never put the power cord under rugs, near
radiators, stoves or heaters.
• Do not use a damaged power cord or plug. If the power cord is damaged, a qualified service technician must
replace it.
• Do not use an extension cord with the All Purpose Cooler.
Installation and Usage Safety
• Keep the All Purpose Cooler away from direct sunlight and excessive humidity.
• Keep at least 3 inches from the wall.
• Do not lay the All Purpose Cooler down on its side. If for some reason the unit was placed on its side, it must stand
upright for a minimum of 2 hours before operation to allow the compressor to stabilize.
• Connect the water supply to a cold water line only. Feed water over 105°F (41°C) can damage the filters.
• Never install the system where it could freeze.
• If the feed water pressure is over the recommended operating pressure of 60 psi (4 bar), install a pressure-reduc-
ing valve in the water line. Be aware of pressure transients.
• Filters should be replaced on schedule. Overused filters will deteriorate the performance of the system.
• Drain the water out of the All Purpose Cooler after long periods of non-use; this will allow a fresh batch of water to
fill the system.
Safety Information
To Next Page