MANUAL CYCLING 15
Manual Cycling
The Culligan
®
microprocessor can be indexed through the various regeneration stages. For all steps, the cycle
numbers do not appear, or change, until the motor stops.
1. Press the status button to move past the programming steps
until the display is blank. From blank display press the “+”
key. An "H" will appear in the display. The control is in the
HOME position.
2. Press and hold the regen button. The 'REGEN' icon will blink,
and the motor will advance the control. A '1' will appear. The
unit is now in the BACKWASH position. The numbers to the
right indicates the time remaining for the cycle.
3. Press the “+” key. A '2' will appear in the display, along
with the cycle time remaining. The control is in the BRINE
DRAW/SLOW RINSE cycle.
4. Press “+” key. A '3' will appear in the display, along with the
cycle time remaining. The control is now in the FAST RINSE/
BRINE REFILL cycle.
5. Press the “+” key. An 'H' will appear in the display. The unit
is in the HOME position. The 'REGEN' enunciator is no lon-
ger blinking.
6. Press the status key. Time-of-Day appears in the display.
Note: If the “+” key is pressed to cycle the value from position “3”
to “Home”, the # regen counters will not be updated.
H 00
REG
I I0
REG
2 7 I
REG
3 08
REG
H 00
7:28
PM
To Next Page
Loading...
Need help?
General
