85
Troubleshooting
If there is a problem, refer to this Troubleshooting Guide.
The Camera Flash cannot be charged.
• The battery is installed in the wrong direction.
Install the battery in the correct direction.
• The camera ash’s internal battery is exhausted.
If <
> appears and blinks on the LCD panel, replace the
battery immediately.
The Camera Flash does not re.
• The camera ash is not attached securely to the camera.
Attach the camera’s mounting foot securely to the camera.
• The electrical contacts of the Camera Flash and camera are
dirty.
Clean the contacts.
• <
> or < > is not displayed in the view nder of camera.
Wait until the ash is fully recycled and the ash ready
indicator lights up.
If the ash ready indicator lights up, but <
> or < > is not
displayed in the view nder, check whether this ash unit is
securely attached to the camera hotshoe.
If the ash ready indicator does not light up after a long wait,
check whether the battery power is enough. If the battery
power is low, <
> will appear and blink on the LCD panel.
Please replace the battery immediately.
The power turns off by itself.
• After 90 seconds of idle operation, auto power off took effect
if the ash is set as master.
Press the shutter button halfway or press any ash button
to wake up.
• After 60 minutes (or 30 minutes) of idle operation, the ash
unit will enter sleep mode if it is set as slave.
Press any ash button to wake up.
Auto zoom does not work.
• The camera ash is not attached securely to the camera.
Attach the camera ash’s mounting foot to the camera.
The ash exposure is underexposed or overexposed.
• There was a highly reective object (e.g. glass window) in the
picture.
Use FE lock (FEL).
• You used high-speed sync.
With high-speed sync, the effective ash range will be
shorter. Make sure the subject is within the effective ash
range displayed.
• You used Manual Flash mode.
Set the ash mode to ETTL or modify the ash output.
Photos have dark corners or only parts of the target subject
are illuminated.
• The focal length of lens exceeds the ash coverage.
Check the ash coverage you set. This ash unit has the
ash coverage between 20 and 200mm, which ts medi-
um-format cameras. Pull the wide panel out to extend the
ash coverage.
616x0_CUlight_FR60X_BDA_Canon englisch.indd 85 24.10.2016 13:56:36
To Next Page
Loading...
