CUMMINS ALLISON JetScan iFX i100 - Feed Errors

Stopping conditions and recovery steps | JetScan iFX
®
i100 scanner | 15
Condition The machine identied a
hardware problem upon startup.
Action The MACHINE START WARNING
screen will identify errors, including:
•DENSITYSENSORISDIRTYOR
BLOCKED.
Corrective action should be taken.
If the error cannot be resolved, call
aCumminsAllisonrepresentative.
Feederrors
Conditions
•Themachinedetecteddocumentsthat
were not adequately spaced apart.
•Themachinemayhaveprocessedtwo
or more documents as one.
Action Remove all documents from the
pocket and put them on the hopper. Press
CONT.
If an alarm repeatedly occurs, adjust the
gray thickness dial on top of the machine
behind the hopper extension. Rotate in
the negative (-) direction as indicated by
the numbers on the front of the thickness
dial.
Press OK to return to the main screen and begin processing.
If the machine is turned OFF and then turned ON, and corrective action has not been
taken, the MACHINE START WARNING screen will appear again.