CUMMINS ALLISON JetScan iFX i100 - Page 28

28 | JetScan iFX
®
i100 scanner | Daily cleaning procedures
Turn power OFF (rocker panel to 0).
Grasp release sleeve on power-cord
connector. Disconnect power cord
from machine.
Lift adjustable hopper to the upright position.
Push release levers down to disengage the
upper-transport plate.
Use a dry microber towel to clean the black start
sensor at the top, middle of the feeder plate (shown
at left).
Use a Simple Green Safety Towel to clean all
rubber sections of the large, black feed rollers.
Rotate the rollers.
Next, use a Simple Green Safety Towel to clean the
at, center rubber-drive tire (shown at left).
Lift display panel to the upright position.
Lift upper-transport plate to the locked position.
Flat, center rubber-drive tire
Release
sleeve
1
2
3
4
5
6
7
8