CUMMINS ALLISON JetScan iFX i100 - DENSITY ADJ (Density Adjustment)

Daily cleaning procedures | JetScan iFX
®
i100 scanner | 29
Vacuum underneath the
upper-transport plate
(shown at far left), as well
as the top of the lower-
transport plate (shown
at left).
Use a dry microber towel to clean the stacking sensor.
Next, use a dry microber towel to clean the stacking-sensor reector, which is
located on the upper-transport plate directly above the stacking sensor.
Press down on the release levers to unlock the upper-transport plate from the
open position. Press down on the upper-transport plate until it locks in the
closed position.
Use a dry microber towel to wipe buildup off
the image sensors shown at left.
Lower display panel to the operating position.
Image sensors
Use a dry microber towel or vacuum to remove any remaining dust in the pocket.
Use a dry microber towel to clean the pocket-sensor lens located in the pocket
between the two gray stacker wheels.
Next, use a dry microber towel to clean the pocket mirror located directly
across from the pocket-sensor lens.
Clean the touch-panel display with a dry microber towel.
9
10
11
12
14
15
16
13
Avoid damaging touch-panel display.
Only clean touch-panel display with dry microber towel as
directed.
Helv. Bold
Oblique
41.29