CUMMINS INLINE 7 - Page 2

Cummins INLINE™ 7 Data Link Adapter Installation and Setup Manual. The Cummins INLINE™ 7 was designed
and manufactured by IDSC Holdings LLC for Cummins Inc.
IDSC Holdings LLC retains all ownership rights to INLINE 7 Data Link Adapter design and its documentation. The INLINE
7 Data Link source code is a confidential trade secret of IDSC Holdings LLC. You may not decipher or de-compile the
INLINE 7 Data Link Adapter, develop source code for the INLINE 7 Data Link Adapter, or knowingly allow others to do so.
The INLINE 7 Data Link Adapter and its documentation may not be sublicensed or transferred without the prior written
consent of IDSC Holdings LLC.
This manual, as well as the software it describes, is furnished under license and may only be used or copied in accordance
with the terms of such license. The content of this manual is furnished for informational use only, is subject to change without
notice, and should not be construed as a commitment by IDSC Holdings LLC. IDSC Holdings LLC assumes no responsibility
or liability for any errors or inaccuracies that may appear in this book.
Except as permitted by such license, no part of this publication may be reproduced, or transmitted, in any form or by
any
means, electronic, mechanical, or otherwise, without the prior written permission of IDSC Holdings LLC.
The Cummins logo and INLINE 7 are trademarks of Cummins, Inc. The Bluetooth word mark and logos are
registered trademarks owned by Bluetooth SIG. Other trademarks and trade names are those of their respective
owners.
©2016 IDSC Holdings LLC. All rights reserved. All other marks are trademarks or registered trademarks of the
respective holders. Pictures for illustration purposes only. Specifications are subject to change without notice.
The transmitter modules contained in this product comply with regulatory standards EN 300 328 and EN 301 489-1/
-17. Human exposure of these modules is below the SAR limits specified in EU recommendation 1995/519/EC.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. A distance of 20cm minimum should be maintained between the
product and all persons during operation. This device contains FCC-IDs : 2AJFJ-USBL2-IL7, QOQWT41.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Part No. 965062 Revised 02/20/2018