height 45
1
⁄4"
width 32
1
⁄2"
length 44"
weight 615 lbs (with shoes)
power
requirement 120 Vac 20 amp GFCI protected circuit
capacity
1
⁄2" thru 2" Rigid conduit
1
⁄2" thru 2" EMT conduit
1
⁄2" thru 2" IMC conduit
1
⁄2" thru 2" Rigid aluminum conduit
1
⁄2" thru 2" schedule 40 steel pipe
1
⁄2" thru 2" 40 mil PVC coated Rigid conduit —
(with optional shoe and roller support)
NOTE: The 747 Omni Bender is NOT to be used for bending any
conduit or steel pipe with wall thickness above schedule 40.
6
FEATURES
• Only two shoes needed to bend 1/2" to 2" Rigid, EMT and IMC conduit.
Optional shoe set bends 1/2" to 2" 40 mil PVC coated Rigid conduit.
• Proven electrical control system.
• Four large casters for ease in moving.
• Remote pendant with magnet.
• Fork pockets for easy lifting.
• Tilts for horizontal bending in a table top position.
• Quick squeeze adjustment for EMT, IMC and Rigid conduit support rollers.
• Adjustable bend angle limit switch for accurate repeat bends.
• Four leveling screws for stability and leveling when bending.
• Lockable storage box for accessories.
• Position locking screw to remove excess play in bender power unit.
SPECIFICATIONS – 747 OMNI BENDER
Bend Radius Chart
Size EMT IMC Rigid PVC Coated Rigid
1/2" 4-5/16" 4-1/4" 4-1/4" 4-1/4"
3/4" 5-1/2" 5-7/16" 5-7/16" 5-7/16"
1" 7" 6-15/16" 6-15/16" 6-15/16"
1 1/4" 8-13/16" 8-3/4" 8-3/4" 8-3/4"
1 1/2" 8-3/8" 8-1/4" 8-1/4" 8-1/4"
2" 9-1/4" 9" 9" 9"
To Next Page
Loading...