OPERATING INSTRUCTIONS
— CONTINUED
30
Rope must ALWAYS be pulled over a rotating sheave. If a sheave does not
rotate, turn cable puller off immediately and determine the problem before
continuing the pull.
WARNING
Pulling Rope should be the only thing to contact the capstan. NEVER let
swivels, grips, etc. come in contact with the capstan.
WARNING
NEVER allow the rope to overlap on the capstan. If this condition begins to
occur, immediately release the tailing force on the rope so that the rope
can feed back toward the conduit or cable tray. If this does not remedy the
overlap, turn off the cable puller immediately. There is no known solution
for rope overlap.
WARNING
Keep as much rope confined in the conduit as possible. This will help
prevent injury should the rope break and whip violently.
WARNING
When making a vertical cable pull, keep the area underneath the cable pull
clear of all personnel.
WARNING
To Next Page
Loading...