Curtis 1238SE - Figure 9: Throttle Mapping (Torque Control Mode); Figure 10: Effect of Gear Soften Parameter (Torque Control Mode); Figure 11: Effect of Brake Taper Speed Parameter (Torque Control Mode)

4 — PROGRAMMABLE PARAMETERS
Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE/38SE Manual, os 31 – May 2017 Return to TOC
pg. 42
MOTOR
RPM +
Neutral Taper Speed
MOTOR
RPM -
Creep Torque
CURRENT +
CURRENT -
In torque mode, the throttle command
continuously interpolates between the
Throttle=0% and Throttle=100% curves
to produce the torque command.
Throttle=100% Curve
Neutral Braking
x
Regen Current Limit
Drive Current LimitRegen Current Limit
Throttle=0% Curve
Forward/Back
Full Restraint Speed
Figure 9
rottle mapping (torque control mode).
TIME
TORQUE
Gear Soften = 0%
= 25%
= 50%
= 75%
= 100%
Figure 10
Eect of Gear Soen parameter
(torque control mode).
MOTOR RPM +
The Brake Taper Speed setting
determines where these knees occur.
MOTOR RPM -
MAXIMUM
BRAKING
CURRENT
(percent)
100
0
0
Figure 11
Eect of Brake Taper Speed
parameter (torque control mode).