Curtis 1238SE - Monitor Menu; Motor Menu; Controller Menu

5 — MONITOR MENU
pg. 69
Return to TOC Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE/38SE Manual, os 31 – May 2017
5 — MONITOR MENU
rough its Monitor menu, the 1313 handheld and 1314 PC programmers provide access to real-time
data during vehicle operation. is information is helpful during diagnostics and troubleshooting,
and also while adjusting programmable parameters and the vehicle’s initial setup.
Table 4 Monitor Menu: 1313/1314 Programmer
INPUTS MENU................... p. 70
— Throttle Command
— Throttle Multiplier
— Mapped Throttle
— Throttle Pot
— Brake Command
— Mapped Brake
— Pot2 Raw
— PD Throttle
— Steer Pot
— Steer Angle (deg)
— Interlock
— Emer Rev
— Analog 1
— Analog 2
— Switch 1
— Switch 2
— Switch 3
— Switch 4
— Switch 5
— Switch 6
— Switch 7
— Switch 8
— Driver 1 Input
— Driver 2 Input
— Driver 3 Input
— Driver 4 Input
— PD Input
— DigOut6 Input
— DigOut7 Input
— Switch 16
OUTPUTS MENU.................................... p. 72
— Analog Out
— Digital Out 6
— Digital Out 7
— Driver 1 PWM
— Driver 2 PWM
— Driver 3 PWM
— Driver 4 PWM
— PD PWM
— PD Current
— 5 Volts
— 12 Volts
— Ext Supply Current
— Pot Low
BATTERY MENU..................................... p. 73
— BDI
— Capacitor Voltage
— Keyswitch Voltage
MOTOR MENU........................................ p. 73
— Motor RPM
— Max Speed Controller Limit
— Temperature
— MotorSpeed A
— MotorSpeed B
— Sin Input A
— Cos Input B
— Rotor Postion
CONTROLLER MENU............................ p. 74
— Current (RMS)
— Modulation Depth
— Frequency
— Temperature
— Main State
— EMBrake State
— Regen
— Master Timer
— VCL Error Module
VEHICLE MENU..................................... p. 77
— Vehicle Speed
— Vehicle Odometer
— Vehicle Acceleration
— Time to Speed 1
— Time to Speed 2
— Time Between Speeds
— Time to Dist 1
— Time to Dist 2
— Time to Dist 3
— Braking Distance Captured
— Distance Since Stop
— Distance Fine
CAN STATUS MENU............................. p. 78
— CAN Node ID
— CAN NMT State
— PDO1 MOSI Byte Map
— PDO1 MISO Byte Map
— PDO2 MOSI Byte Map
— PDO2 MISO Byte Map
— VCL Error
— Motor Characterization Error
— Parameter Mismatch Error
— Supervision Error
— CUTBACKS................................. p. 76
— Motor Temp Cutback
— Controller Temp Cutback
— Undervoltage Cutback
— Overvoltage Cutback
— MOTOR TUNING ........................ p. 76
— Motor RPM
— Base Speed Captured
— Test Field Current