Curtiss-Wright DuraNET 3300 - Horizontal Mounting

User Manual – DuraNET 3300
Specifications
MNL-0676-01 Rev A4
ECO- N/A
Effective: 26 Feb 21
Page 67 of 84
Horizontal Mounting
To install the DuraNET 3300 on its side (horizontal):
3. Create a hole pattern on the mounting surface that matches the pattern shown in Figure 5.3. The
mounting holes are 0.33” in diameter.
4. Attach the switch to the mounting surface using the two side mounting holes. Attachment screws
should be 5/16-18.
Important!
Ensure that mounting screw length allows proper thread engagement of the mounting hardware but is
not so long that the screw bottoms out in the side mounting hole.
Figure 5.3: Side Mounting Holes