CUSHCRAFT R9 - Assemble Radiator Tubes

6
#4- ASSEMBLE RADIATOR TUBES
BA BASE 1
ASSEMBLY
BB R8TUBEBB 1-1/4” x72” 1
11/8” insert (3.17x182.9cm)
BC R8TUBEBC 1-1/8” x72” 1
1” insert (2.9x182.9cm)
BD R8TUBEBD 1” x36” 1
(2.5x91cm
)
411 030411 SSWORM 9/16” x1-1/4” 1
CLAMP (1.4x3.2cm)
412 030412 SSWORM 11/16” x1-1/2” 1
CLAMP (0.7x3.8cm)
413 030413 SSWORM 3/4” x1-3/4” 1
CLAMP (1.9x4.4cm
)
KEY P/NDISPLAY
DESCSIZEQT
Y
Slide theTube BD into tube BC until it hits the inner tube, and secure it
with worm clamp (411).Slide this assembly into tube BB and secure it
with worm clamp (412). Make sure that plastic insulators are aligned as
shown in Fig. "G".
Insert assembly consisted of tubes BD,BC and BB 4 -1/2 " into base
assembly (BA) and secure it with worm clamp (413).We recommend
that you use workhorses or two chairs to place thisassembly in a horizontal
position .You may or may not attach the stainless radial rods (32) to the
base assembly (BA) at this time as mentioned in Section#2 of this
manual.
413
BA
BB
BD
411
412
BC
4-1/2”
INSERT
(11.4 cm)
BA
BB
8”
INSERT
BB
BC
BB
BC
FIGURE G
R9
7/8” insert