5.2 Setup report
and the description of device parameters see the following paragraphs.
PRINTER NAME and
FIRMWARE RELEASE
PRINTER SETUP
INTERFACE ...................................RS232
PROGRAM MEMORY TEST..........OK
DYNAMIC RAM TEST....................OK
EEPROM TEST..............................OK
CUTTER TEST...............................OK
HEAD VOLTAGE [V] = 24.01
HEAD TEMPERATURE [°C] = 23
PAPER PRINTED [cm] = 4695
CUT COUNTER = 263
RETRAC COUNTER = 0
FPD = 0
POWER ON COUNTER = 12
PRINTING HEAD TYPE = T80
RS232 Baud Rate .....................: 19200 bps
RS232 Data Length...................: 8 bits/chr
RS232 Parity .............................: None
RS232 Handshaking .................: Xon/Xoff
Busy Condition ..........................: RcFull
USB Address Number ...............: 0
Autofeed ....................................: CR Disabled
Print Mode .................................: Normal
Chars / inch ...............................: A=15 B=20 cpi
Speed / Quality..........................: Normal
Paper Retracting .......................: Disabled
Notch Alignment ........................: Enabled
Notch Threshold ........................: 1.98V
Notch Distance [mm] .................: + 00
Current ......................................: Normal
Left Margin Offset......................: 0
Right Spacer. .............................: None
Font Type...................................: International
Code Table [num] ......................: 00
Print Density..............................: 0%
[FF] key to enter setup
[LF] key to skip setup
<device name>
SCODE. <code> - rel 1.00
FCODE. <code> - rel 1.00
KEYS FUNCTIONS
PRINTER STATUS
PRINTER PARAMETERS
43
To Next Page
Loading...
Need help?
General
