6.2 Cleaning
For periodic cleaning of the device, see the instructions below
Sensors Paper path
1
Disconnect the power supply cable and
open the device cover (see par. 4.3)
2
Clean the device sensors
by using compressed air.
1
Disconnect the power supply cable and
open the device cover (see par. 4.3)
2
Remove any scraps of paper and the accumulated
paper dust on the paper mouths, on the printing roller,
on the cutter and on the area around the sensors.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
52
To Next Page
Loading...
