34/38
Sept.
2014
V3.1
CybTouch 8 PS User Manual
MSG nr. MeSSaGe deScripTion
W39 Moving and counting
directions have inverted
Wizard message: Both the rotary direction of the motor and the
counting have been changed.
W40 OK Indicates a cycle or operation has properly ended.
W41 No movement executed
Axis Wizard message: Operator pressed
but no movement
was made.
W42 Enter next measured angle When using double or triple angle measurement, tells the
operator to enter the next measured value.
W43 OK, correction done Appears when an angle correction has been entered and applied.
W45 Enter unlock interface
password
This message is displayed when parameter P02.04 Level 0 Lock
HMI is set to yes and the screen is touched.
W46 Enter password level 1 or
greater
This message is displayed when a password of level 1 or higher
is needed to execute a specific operation.
W47 Enter password level 3 This message is displayed when a password of level 3 or higher
is needed to execute a specific operation.
W48 Enter new password
These messages are displayed when changing passwords.
W49 Confirm new password
W50 Enter password for backup This message is displayed when trying to create a backup.
W51 Enter password for restore This message is displayed when trying to restore a backup.
W52 Enter password for init This message appears on the page displayed after the system
crashed (soft or hardware problem), when the operator tries to
format the machine.
W53 Enter password for delete all
backups
This message is displayed when trying to delete all backups.
To Next Page
Loading...
