33/38
Sept.
2014
V3.1
CybTouch 8 PS User Manual
MSG nr. MeSSaGe deScripTion
W13 Touch the zoom center
When the zoom function
is activated, indicates that the HMI
will zoom around the next touch on the screen.
W14 Touch to create a new
segment
When creating a new part in the TouchProfile Mode (optional)
(see page 23), this message reminds the operator to touch the
screen to create a part’s segment.
W15 Touch one length or angle to
start the profile
When creating a new part in the L-Alpha Mode (see page 27),
reminds the operator to touch the table to begin creating a part.
W16 Eco mode This message appears when the Eco mode starts, after the timer
defined in the machine parameters is over.
W17 Enter the measured angle This message is displayed when the operator must enter the
physically measured angle value in the Bend Correction page.
W18 Empty field Operator did not enter a value.
W19 24V I/O power on 24V to the inputs/outputs is now available.
W20 Please select a field This message is displayed when trying to set the time (see Set
Clock, page 8) and no field (minute, seconds, etc.) has been
selected.
W21 Set seconds
In the Set Clock (see page 8) page, when the corresponding
field is selected, indicates that it can be set using the up and
down arrows.
W22 Set minutes
W23 Set hour
W24 Set day
W25 Set month
W26 Set year
W27 Touch the small graphic to
toggle screen
This message appears once at the beginning of the bend manual
sequencing, telling the operator that he can toggle from the Bend
Order page to the Bend 2D page simply by touching the graphic
at the bottom of the screen (see Manual Bend Sequencing, page
24).
W29 End of list This message is displayed when reaching the end of the list in
one of the different menus
.
W30 Serial number from 100’000
thru 231’071
This message appears only when entering the serial number. It
indicates the range of the number to be entered. Attention, this
operation is normally done at the factory, with a serial number is
related to the options installed on the machine. Do not change it!
W31 New option code When installing a new option in the Service Page (see
page 10).
W32 Data entry in progress Operation impossible: data entry in progress. Wait until the data
is entered to try again.
W33 Indexation in progress Operation impossible: indexation in progress. Wait until the
indexation is finished to try again.
W34 RFlink disconnected When the RFLink connection to a laptop has been shut down
from the latter.
W35 Access not allowed Operator needs another level password.
W36 Beam not at TDC, move beam
up
W37 Moving direction has been
inverted
Wizard message: Rotary direction of the motor has been
changed.
W38 Counting direction has been
inverted
Wizard message: Counting direction of the axis has been
changed.
To Next Page
Loading...
