32/38
Sept.
2014
V3.1
Interactive
message line
Message number
CybTouch 8 PS User Manual
error and warninG MeSSaGeS
Following is a list of warning and error
messages which may be displayed on the
interactive message line of the CybTouch.
There are two types of messages:
• Warning Messages, which are displayed
on a green background. They are
information or instructions that will
disappear automatically.
• Error Messages (machine or NC
errors), which are displayed on a red
background. They inform the user of an
error occurring on the machine or NC,
and sometimes require intervention by
the end user or a technician.
WarninG MeSSaGeS
MSG nr. MeSSaGe deScripTion
W01 Not implemented This message is displayed when a function is in development but
not yet fully implemented.
W02 Ignore This message appears when the desired action makes no sense,
like for example clearing the indexation when the indexation was
not made.
W03 Code accepted This message is displayed when the correct password has been
entered.
W04 Please press 2 seconds This message reminds the operator to keep the start pump
button
pressed for 2 seconds.
W05 The pump is on This message appears after the pump starting cycle has been
correctly executed.
W06 The pump is off This message indicates that the pump has been stopped.
W07 Select at least one bend This message is displayed when the operator tries to go to the
Bend 2D screen from the Bend Order screen before defining the
first bend of the sequence (see Manual Bend Sequencing, page
24).
W08 Touch OK to continue Indicates that a validation is required to continue.
W09 Step n° This message appears in the More Page (see page 14), it
indicates the step sequence number when browsing through the
program’s steps.
W10 Cycle in progress While this message is displayed, the machine cycle is in progress
and the screen is locked, except for the Stop button.
W11 Machine is indexed Indicates the indexation cycle was successful.
W12 Identification OK In the Axis Wizard, indicates the identification cycle was
successful.
When reporting error messages, please ALWAYS indicate the error number at
the end of the line. This number also refers to the first column in the section
below.
To Next Page
Loading...
