CyberPower PR750RT2U - Page 15

Item
Default
Option
Description
Cycling Display
Never
 Never
 After 10 seconds
 After 20 seconds
 After 30 seconds
After this amount of time with no activity, UPS will start
cycling the status information on LCD screen.
Low Battery Threshold
300 seconds
 0-1800 seconds
The UPS will emit an audible alarm, as a reminder that
remaining runtime is reaching the threshold.
35%
 20-65%
The UPS will emit an audible alarm, as a reminder that
remaining battery capacity is reaching the threshold.
Battery Change Date
---/----
 Month/Year
Optional setup information for users to record the
installation date of battery pack. Reset the data when
replacing new battery pack.
Schedule Test – On
Startup
No
 Yes
 No
If Yes is selected, the UPS will perform Self Test every time
on startup.
Schedule Test –
Frequency
Never
 Never
 Every 1 week
 Every 2 weeks
 Every 3 weeks
 Every 4 weeks
Select the amount of time that the UPS will perform Self
Test periodically after startup.
Date and Time
----/--/-- --:--
 Year/Month/Day
Hour:Minute
Set the Date and Time for use in data/event logs.
Power Meter Reset
No
 Yes
 No
Select Yes to reset the value of Load Energy in Status menu.
IP Access
DHCP
 DHCP
 Manual IP Setup
Select the way to access the IP/Subnet Mask/Gateway. This
shows “No Web Device” when no RMCARD is installed.
IP Address
Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup and then
this item can be adjusted manually. This shows “No Web
Device” when no RMCARD is installed.
Subnet Mask
Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup and then
this item can be adjusted manually. This shows “No Web
Device” when no RMCARD is installed.
Gateway
Auto-sensing
 Auto-sensing
 Manual Key-in
Change the IP Access setting to manual IP Setup and then
this item can be adjusted manually. This shows “No Web
Device” when no RMCARD is installed.
Firmware Update*
*Only displayed in Standby
Mode
No
 Yes
 No
Select Yes to update the firmware of UPS in Standby Mode.
Back to Default
No
 Yes
 No
Select Yes to restore the UPS factory default settings.
LCD OPERATION GUIDE (continued)