Cybex 425T Treadmill Owner’s Manual
Assembly
and Setup
2-2
Electrical Power Requirements
The power requirements for this treadmill are a grounded, dedicated circuit, rated for one of the following:
115 VAC ±5%, 60 Hz and 15 amps; 208/220 VAC, 60 Hz, 100 amps or 230 VAC ±5%, 50 Hz and 10
amps. Contact your electrician to ensure the power supply complies with local building codes.
Do not use a ground plug adapter to adapt the 3-prong power cord plug to a non-grounded electrical
outlet. Do not use an extension cord.
Assembling the Treadmill
WARNING: Use extreme caution when assembling the treadmill. Failure to do so could result in
injury.
CAUTION: A minimum of two people are required to assemble this treadmill.
Tools Required
• 9/16” Socket wrench with a 4” extension
• Phillips screwdriver
NOTE: The words “left” and “right” denote the treadmill user’s orientation.
1. Read and understand all instructions thoroughly before assembling the treadmill.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describe the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Verify you have received the correct package.
Read the sticker on the outside of the box and verify that the model number, color and voltage are A.
what you ordered. NOTE: During step 3 and 5 you will verify that the contents of the box match
the sticker.
3. Unpack and verify the contents of the boxes.
Lift up and remove the cardboard sleeve that surrounds the treadmill. A.
Check to be sure that the following items are present. Check off ( B. ) each item as you fi nd it. See
Figure 1. If any of the parts are missing contact Cybex Customer Service.
To Next Page
Loading...
Need help?
General
