20 amps, 208/220 VAC, 60 Hz, 15 amps or 230 VAC ±5%, 50 Hz and 15 amps and a grounded,
dedicated circuit. Make sure that the treadmill is connected to an outlet having the same
configuration as the plug. Do not use a ground plug adapter to adapt the power cord to a
non-grounded outlet.
Important Safety Instructions
(Save These Instructions)
! DANGER: To reduce the risk of electric shock, always unplug this treadmill from the
electrical outlet immediately after using it and before cleaning it.
! WARNING: Serious injury could occur if these precautions are not observed. To reduce
the risk of burns, fires, electric shock, or injury:
• Obtain a medical exam before beginning any exercise program.
• Keep children away from the treadmill. Teenagers and disabled persons must be
supervised while using.
• Stop exercising if you feel faint, dizzy, or experience pain at any time while exercising and
consult your physician.
• Clip the e-stop clip onto your clothing and carefully test it prior to using the treadmill.
• Use the treadmill handrails for support and to maintain balance.
• Use caution when mounting and dismounting the treadmill.
• Disconnect all power before servicing the treadmill.
• Use a dedicated line when operating the treadmill.
• Connect the treadmill to a properly grounded outlet only.
• Do not operate electrically powered treadmills in damp or wet locations.
• Keep the running belt clean and dry at all times.
• Stop and place the treadmill at 0 degrees incline (level) after each use.
• Use this treadmill for commercial use only.
• Do not leave the treadmill unattended when plugged in and running. NOTE: Before leaving
the treadmill unattended, always wait until the treadmill comes to a complete stop and is
level. Then, turn all controls to the STOP or OFF position and remove the plug from the
outlet. Remove the e-stop key from the treadmill.
Cybex Pro Treadmill Owner’s & Service Manual
Page 1-2
To Next Page
Loading...
Need help?
General
