Using and Testing the Emergency Stop System
The treadmill is equipped with an Emergency Stop System. The system consists of a rectangular stop magnet
(located on the upper bridge plastic) attached to a safety stop pull cord.
Before starting a workout, attach the lanyard on the safety stop pull cord to an item of the user's clothing. During
a workout, pull the cord to remove the magnet from the bridge. This will immediately stop the treadmill belt.
Note: Test the safety stop pull cord by attaching the lanyard to a user's item of clothing during operation
of the treadmill. While the treadmill is on and the console display is active, remove the safety stop pull cord
/ magnet from the bridge. A message will be displayed on the console similar to "Replace the emergency
stop switch". With the safety stop pull cord removed no keys shall function on the treadmill. Place the safety
stop pull cord back in place. The treadmill will reset and will be ready for operation.
Page 14 of 31
To Next Page
Loading...
Need help?
General
