EasyManua.ls Logo

cypress solutions CTM-ONE - User Manual

cypress solutions CTM-ONE
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Model
CTM-ONE (M) (PLUS)
Revision
Revision 1.0
CTM-ONE MANUAL
MANUAL: CTM-ONE
3066 Beta Avenue | Burnaby, B.C. | V5G 4K4
© 2021 Cypress Solutions

Table of Contents

Other manuals for cypress solutions CTM-ONE

Preview: Installation
Installation6 pages

Questions and Answers

  • D
    Doris HurstAug 10, 2025
    What to do if the Cellular LED is off on my Cypress Solutions Transmitter?
    • A
      Ashley KerrAug 10, 2025
      If the Cellular LED is off on your Cypress Solutions Transmitter, it could be due to several reasons. First, the CTM ONE might be in an area with no cellular activity, meaning no RF signal is available. Second, the cellular device may not be registered on the network, so ensure the radio module/device/SIM has been activated. Finally, there might be an incorrect configuration of the internal radio module; ensure the correct device has been configured.
  • D
    Diana SmithAug 15, 2025
    Why is the GPS LED flashing on my Cypress Solutions Transmitter?
    • C
      Christopher WarrenAug 15, 2025
      The GPS LED flashes on your Cypress Solutions Transmitter because there is no valid GPS fix. The GPS antenna requires a clear view of the sky to obtain a valid GPS fix.
  • W
    William MartinezAug 20, 2025
    Why is the PWR LED flashing on my Cypress Solutions Transmitter?
    • M
      Manuel LeeAug 20, 2025
      The PWR LED might be flashing on your Cypress Solutions Transmitter for a few reasons: * The device could be in standby mode. Ensure the standby signal is connected to greater than 9VDC. * The supply voltage might be insufficient. Ensure the supply voltage is greater than 9VDC. * The device is designed to enter standby mode if the standby signal is off after a configured time period (e.g. 10 seconds by default).
  • T
    Tracie YangAug 25, 2025
    What to do if Cypress Solutions Transmitter is constantly rebooting?
    • D
      David GallagherAug 26, 2025
      If your Cypress Solutions Transmitter is constantly rebooting every 4 minutes with no user input, and only the PWR and GPS LEDs are on, it may be due to an incorrectly configured cellular device. Ensure the CTM ONE is configured correctly with the appropriate cellular device.
  • J
    Jacob BakerAug 30, 2025
    What does it mean if the Cellular LED is solid or flashing on my Cypress Solutions Transmitter?
    • T
      Tammy HuangAug 30, 2025
      The Cellular LED being solid or flashing on your Cypress Solutions Transmitter indicates that the CTM ONE is registered on the network and is in an area of 3G or 4G coverage, but the device has not obtained an IP address.
  • B
    bakerdanielleSep 4, 2025
    How to fix all LEDs remaining off when Cypress Solutions Transmitter is powered?
    • J
      Jessica BoyleSep 4, 2025
      If all LEDs remain off when your Cypress Solutions Transmitter is powered, check the power supply to ensure a minimum of 9 VDC is being supplied.

cypress solutions CTM-ONE Specifications

General IconGeneral
Wi-Fi802.11 b/g/n
GNSSGPS/GLONASS
Power Supply9-36 V DC
InterfacesEthernet, USB, Serial
ProcessorARM Cortex-A7
Memory512 MB RAM
USB Ports1 x USB 2.0
Product TypeGateway
Cellular4G LTE
Bluetooth4.2
Operating SystemLinux
Storage4 GB Flash
Serial Ports1 x RS-232/RS-485

Related product manuals