D-Link DAP-1513 - Industry Canada Statement

45D-Link DAP-1513 User Manual
Appendix E - Warranty
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
1) this device may not cause interference and
2)thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesiredoperationofthedevice
Thisdevicehasbeendesignedtooperatewithanantennahavingamaximumgainof2dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.
Toreducepotentialradiointerferencetootherusers,theantennatypeanditsgainshouldbesochosenthattheEIRPisnot
more than required for successful communication.
Caution:
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel
mobile satellite systems.
Becausehighpowerradarsareallocatedasprimaryusers(meaningtheyhavepriority)in5250-5350MHzand5650-5850MHz,
theseradarscouldcauseinterferenceand/ordamagetolicenseexemptLANdevices.
IMPORTANT NOTE:
ICRadiationExposureStatement:
ThisequipmentcomplieswithICradiationexposurelimitssetforthforanuncontrolledenvironment.Thisequipmentshould
be installed and operated with minimum distance 20cm between the radiator and your body.
The availability of some specic channels and/or operational frequency bands are country dependent and are rmware
programmed at the factory to match the intended destination. The rmware setting is not accessible by the end user.
For detailed warranty information applicable to products purchased outside the United States, please contact the
corresponding local D-Link oce.