DAP-1610 AC1200 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Con"guring Wireless Network
This configuration step is available for the Access point and Repeater modes.
1. On the Wireless Network 2.4 GHz page, in the Network name field, specify your own
name for the wireless network in the 2.4GHz band or leave the value suggested by the
extender.
2. In the Password field, specify your own password for access to the wireless network or
leave the value suggested by the extender (WPS PIN of the device, see the barcode label).
3. You can restore the parameters of the wireless network specified before resetting to factory
defaults. To do this, click the RESTORE button.
Figure 27. The page for configuring the wireless network.
4. Click the NEXT button to continue or click the BACK button to specify other settings.
5. On the Wireless Network 5 GHz page, specify needed settings for the wireless network
in the 5GHz band and click the NEXT button.
Page 32 of 91
To Next Page
Loading...
Need help?
General
