DAP-1620 AC1300 MU-MIMO Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
The following buttons are also available on the page:
Control Description
Factory
Click the button to restore the factory default settings. Also you can
restore the factory defaults via the hardware RESET button (see the
Bottom Panel section, page 12).
Backup
Click the button to save the configuration (all settings of the
extender) to your PC. The configuration backup will be stored in the
download location of your web browser.
Restore
Click the button and follow the dialog box appeared to select a
previously saved configuration file (all settings of the extender)
located on your PC and upload it.
Save
Click the button to save settings to the non-volatile memory.
The extender saves changed settings automatically. If changed
settings have not been saved automatically, a notification is
displayed in the top right part of the page.
Reboot
Click the button to reboot the device. All unsaved changes will be
lost after the device's reboot.
In the Idle time field specify a period of inactivity (in minutes) after which the extender completes
the session of the interface. By default, the value 5 is specified. Then click the SAVE button.
Page 102 of 125
To Next Page
Loading...
