DAP-1620 AC1300 MU-MIMO Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Configuring Wireless Network
1. On the Wireless Network 2.4 GHz page, in the Network name field, specify your own
name for the wireless network or leave the value suggested by the extender.
2. In the Password field, specify your own password for access to the wireless network or
leave the value suggested by the extender (see the field Password on the back panel of the
device).
3. If the extender is used as a Wi-Fi client, you can specify the same parameters of the wireless
network as specified for the network to which you are connecting. To do this, click the USE
button (available for the Repeater mode).
4. You can restore the parameters of the wireless network specified before resetting to factory
defaults. To do this, click the RESTORE button.
Figure 37. The page for configuring the wireless network.
5. Click the NEXT button to continue or click the BACK button to specify other settings.
6. On the Wireless Network 5 GHz page, specify needed settings for the wireless network
in the 5GHz band and click the NEXT button.
Page 45 of 125
To Next Page
Loading...
