802.11 b/g /n Access Point Command Line Interface Manual
3
1
USING THE CLI
The DAP-2695 can be accessed by Telnet. Using Microsoft Windows Operation system as example, open the Command Prompt on the computer that will be used for
configuring and managing the AP and enter telnet and IP address of DAP-2695 in the first line. Using the default IP address as example, enter telnet 192.168.0.50 to
cause thefollowing screen to open: (picture on the left)
Press Enter in the screen above. The following screen opens: (picture on the right)
To Next Page
Loading...
