D-Link DAP-2695 Command Line Interface Reference Manual

802.11 b/g /n Access Point Command Line Interface Manual
32
13
OTHER COMMANDS
Intrusion Command:
Function
Syntax
get intrusion
Display intrusion
get intrusion
set intrusion
Set intrusion
set intrusion
Schedule Commands
Function
Syntax
get scheduled
Display scheduled
get scheduled
set scheduled
Set scheduled
set scheduled
QoS Commands
Function
Syntax
get qos
Quality of Service
get qos
set qos
Quality of Service
set qos
ARP Spoofing Prevention
Commands
Function
Syntax
get arpspoofing
Display ARP Spoofing
get arpspoofing
set arpspoofing
Set ARP Spoofing
set arpspoofing
Macclone Commands
Function
Syntax
get macclonetype
Display MAC address clone type
get macclonetype
get maccloneaddr
Display MAC clone address
get maccloneaddr
set macclonetype
Set MAC address clone type
set macclonetype
set maccloneaddr
Set MAC clone address
Zonedefence Commands
Function
Syntax
get zonedefence
Display Zonedefence
get zonedefence
get zonedefence-ip
Display Zonedefence IP table list
get zonedefence-ip

D-Link DAP-2695 Specifications

Operating Environment

operating temperature	0˚C to 40˚C
storage temperature	-20˚C to 65˚C
operating humidity	10%~90% (non-condensing)
storage humidity	5%~95% (non-condensing)

Power

operating voltage	48V DC +/- 10% for PoE
voltage and current for PoE	48V/0.5A

Wireless Specifications

wireless frequency range	2.4 to 2.4835 GHz and 5.15 to 5.85 GHz
antenna type at 2.4GHz	3x Detachable 4 dBi Omni antennas
antenna type at 5GHz	3x Detachable 6 dBi Omni antennas

Weight and Dimensions

length	198.8 mm
width	190 mm
height	36.5 mm