D-Link DAP-2695 - LAN

802.11 b/g /n Access Point Command Line Interface Manual
21
7
VLAN COMMAND
Get Command:
Function
Syntax
get vlanstate
Display VLAN state
get vlanstate
get vlanmode
Display VLAN mode
get vlanmode
get autosetpvid
Display auto setting pvid by group VID
get autosetpvid
get pvid_primary
Display primary SSID PVID
get pvid_primary
get pvid_eth
Display ethernet PVID
get pvid_eth
get pvid_sys
Display system PVID
get pvid_sys
get groupvid_primary
Display wlan port member of group VID
get groupvid_primary
get groupvid_eth
Display LAN port member of group VID
get groupvid_eth
get groupvid_sys
Display System port member of group VID
get groupvid_sys
get wds-pvid
Get PVID of WDS[index]
get wds-pvid
get wds-groupvid
Get group VID of WDS[index]
get wds-groupvid [index]
get wds-updownlink
Get uplink/downlink state of WDS[index]
get wds-updownlink [index]
get multi-pvid
Display PVID of Multi-SSID[index]
get multi-pvid [index]
get multi-groupvid
Display Group VID of Multi-SSID[index]
get multi-groupvid [index]
Set Command:
Function
Syntax
set vlanstate
Set VLAN state
set vlanstate
set vlanmode
Set VLAN mode
set vlanmode
set autosetpvid
Auto setting pvid by group VID
set autosetpvid
set pvid_primary
Set primary SSID PVID
set pvid_primary
set pvid_eth
Set ethernet PVID
set pvid_eth