29D-Link DCS-934L User Manual
Section 4 - Conguration
Network Setup
Select this connection if you have a DHCP server running on your network and
would like an IP address to be assigned to your camera automatically. If you
select DHCP, do not specify the IP address settings below.
Select this option for a xed IP address. You can obtain a static IP address and
other network information from your network administrator for your camera. A
static IP address will simplify access to your camera in the future.
• IP Address: Enter the xed IP address for your camera.
• Subnet Mask: The default value is “255.255.255.0.” Used to determine if the
destination is the same subnet as host devices.
• Default Gateway: Enter the gateway address used to forward frames to
destinations in a dierent subnet. Invalid gateway settings may cause the
failure of transmissions.
If you are using a PPPoE connection, click to enable it and enter the User ID
and Password for your PPPoE account. You can get this information from your
Internet service provider (ISP).
Enter the IP addresses for Primary and Secondary domain name servers if you
wish to use them. (The IP addresses can be obtained from your ISP.)
You may congure a Second HTTP port that will allow you to connect to
the camera using a standard web browser. The port can be set to a number
other than the default TCP port 80. A corresponding port must be opened
on the router. For example, if the port is changed to 1010, users must type
http://192.168.0.100:1010 instead of only “http://192.168.0.100”.
Enable this setting to congure your camera as an UPnP (Universal Plug and
Play) device in the network.
Enable this setting to allow your camera to use UPnP to congure port forwarding
on your router.
DHCP
Connection:
Static IP Address:
PPPoE:
Primary/
Secondary DNS:
HTTP Port:
UPnP:
UPnP Port
Forwarding:
This section allows you to congure your network settings for your camera.
To Next Page
Loading...
Need help?
General
