To change the port setting, click on the ID parameter to enter to the
selected port to configure its Speed/Disable, Flow control and QoS
setting.
Figure 18.
Speed:
Port 1~9: This setting has six modes -- 100M Full, 100M Half, 10M
Full, 10M Half, Auto and Disable for speed or port disable selections.
Port 10: This setting has three modes -- 1G Full, Auto and Disable
for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set Flow Control to Enable for avoiding data transfer
overflow. Or it sets to Disable; there is either no flow control or other
hardware/software management.
When the port is set to forced mode, then the flow control will
automatically set to Disable.
QoS:
In some ports that need to have a high priority to manage the data
transfer, QoS should be change. Set the port’s QoS to high to
determine the port will always transfer their data first.
32
To Next Page
Loading...
