D-Link DES-2110 - VLAN CLI Commands

71
VLAN Commands
The VLAN commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
create vlan
[<vlan_name 8> | tag <vlanid
1~4094>]
delete vlan
<vlan_name 8> {tag <vlanid
1~4094>}
config vlan
[<vlan_name 8> { tag <vlanid
1~4094>} [add {[tagged |
untagged]}| delete] <portlist>
show vlan
{[<vlan_name 8> | tag <vlanid
1~4094>]}
enable port_based vlan
disable port_based
vlan
enable 802.1q_based
vlan
Command Parameters
disable 802.1q_based
vlan
config pvid
<portlist> <vlanid 1~4094> priority
<0-7>
Each command is listed, in detail, in the following sections.
create vlan
Purpose
Used to create a VLAN on the Switch.
Syntax create vlan [<vlan_name 8> | tag <vlanid
1~4094>]
Description
This command allows you to create a VLAN on
the Switch.