60
Basic Switch Commands
The basic switch commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
show switch
config system
auto_logout <value 3 ~ 30>
config system_name
{<system_name >}
config location_name
{<location_name>}
reset
<config>
logout
save
Each command is listed, in detail, in the following sections.
show switch
Purpose
Used to display general information about the
Switch.
Syntax show switch
Description
This command displays information about the
Switch.
Parameters
None.
To Next Page
Loading...
