D-Link DES-2110 - Trap CLI Commands

Example usage:
To display port mirroring configuration:
Figure 77. show mirror command
Trap Commands
The trap mirroring commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config discovery
trap_ip
ipaddress <ip_address> {vid
<vlan_id>}
config discovery
trap_event
{[bootup | illegal_login | t_rx_err |
t_tx_err| f_rx_err | f_tx_err|
f_link_change]}
delete discovery
trap_event
{[bootup | illegal_login | t_rx_err |
t_tx_err| f_rx_err | f_tx_err|
f_link_change]}
show discovery trap
82