D-Link DES-2110 - Show IP Interface Command; Switch Port CLI Commands

67
show ipif
Purpose
Used to display the configuration of an IP
interface on the Switch.
Syntax show ipif
Description
This command will display the configuration of an
IP interface of the Switch.
Parameters
None.
Example usage:
To display IP interface settings:
Figure 59. show ipif command
Switch Port Commands
The switch port commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
config ports
[<portlist | all> {speed [disable |auto
|10_half | 10_full | 100_half | 100_full |
1000_full} | {flow_control [enable |
disable] | qos {normal | high]}
show ports
{portlist}