Each command is listed, in detail, in the following sections.
config ipif
Purpose
Used to configure the System IP interface.
Syntax config ipif [ipaddress <network address> |
{gw <ipaddress>} | dhcp {vid <vlan_id>}]
Description
This command is used to configure the System
IP interface on the Switch.
Parameters ipaddress <network address> - IP address and
netmask of the IP interface to created. You can
specify the address and mask information using
traditional format (for example,
Parameters
192.168.100.100/255.255.255.0 of in CIDR
format, 192.168.100.100/24.
dhcp - Allows the selection of the DHCP protocol
for the assignment of an IP address to Switch’s
system IP address.
<vlan_id> - Specific the 802.1Q VLAN ID to the
Switch. The range between 1 to 4094.
Example usage:
To configure the IP interface System:
Figure 58. config ipif command
66
To Next Page
Loading...
