65
save
Purpose
Used to save changes in the Switch’s
configuration to non-volatile RAM.
Syntax save
Description
This command is used to enter the current switch
configuration into non-volatile RAM. The saved
switch configuration will be loaded into the
Switch’s memory each time the Switch is
restarted.
Parameters
None.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
Figure 57. save command
Basic IP Commands
The basic IP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
config ipif
[ipaddress <network address> {gw
<ipaddress>} | dhcp {vid <vlan_id>}]
show ipif
To Next Page
Loading...
