Each command is listed, in detail, in the following sections.
config discovery trap_ip
Purpose
Used to configure an IP address of the trap
recipient of Web Management Utility to the
Switch.
Syntax config discovery trap_ip ipaddress
<ip_address> {vid <vlan_id>}
Description
The command is configure an IP address of the
trap recipient of Web Management Utility to the
Switch.
Parameters <ip_address> - IP address of the Web
Management Utility.
<vlan_id> - Specific the 802.1Q VLAN ID of Web
Management Utility. The range is between 1 to
4094.
Example usage:
To assigned IP address of the Web Configuration Utility to receive
trap message:
Figure 78. config discovery trap_ip command
83
To Next Page
Loading...
