D-Link DES-2110 - Config Discovery Trap Event Command

84
config discovery trap_event
Purpose
Used to configure the events of the trap on the
Switch.
Syntax config discovery trap_event {[bootup |
illegal_login | t_rx_err | t_tx_err | f_rx_err |
f_tx_err | f_link_change]}
Description
The command is configure the events of the trap
on the Switch..
Parameters bootup - Enabled the Switch’s boot up event.
illegal_login - Enabled the Switch’s illegal login
event.
t_rx_err - Enabled the Switch’s twisted-pair ports
(port 1 – 9) error receive data packets event.
t_tx_err - Enabled the Switch’s twisted-pair ports
(port 1 – 9) error transmitting data packets event.
f_rx_err - Enabled the Switch’s fiber port (port
10) error receive data packets event.
f_tx_err - Enabled the Switch’s fiber port (port
10) error transmitting data packets event.
f_link_change - Enabled the Switch’s fiber port
(port 10) linking status change event.