excluding uplink port” setting), and the Switch will forward data
following the Static MAC Address Table to the specific port. Select
“Disabled”, the Switch will learn and build MAC address table
automatically and the Switch will forward data following the auto
learning MAC Address Table to the specific port.
Disable auto learning excluding uplink port: When enable the
Static MAC function, the Switch’s auto learning function will be
disable, check the dialog box of the “Disable auto learning excluding
uplink port” and then check the dialog box of port numbers to enable
the auto learning function of the port, and the Switch will forward
data following the Static MAC Address Table and the Switch’s auto
learn MAC address table to the specific port.
Figure 35. Configure Static MAC Setting
Add Static MAC rule: Press “Add Mac” button, and the Static MAC
Setting window will pop out; fill in the specific MAC address and
select the specific port. Press “Apply” to add rule to the list.
Figure 36. Add Static MAC
46
To Next Page
Loading...
