D-Link DES-2110 - Config Location Name Command; Reset Command

63
config location_name
Purpose
Used to enter a description of location of the
Switch.
Syntax config location_name {<location_name>}
Description
The command is used to enter a description of
the location of the Switch. A maximum of 20
characters can be used.
Parameters <location_name> - A maximum of 20 characters
is allowed.
Example usage:
To configure the Switch location for “Sales-6F”:
Figure 54. config location_name command
reset
Purpose
Used to reset the Switch to the factory default
setting
Syntax reset <config>
Description
The command is used to restore the Switch’s
configuration to the default setting assigned from
the factory.
Parameters config - All of the factory default settings are
restored on the Switch including the IP address.