D-Link DES-2110 - Config PVID Command

78
disable 802.1q_based vlan
Purpose
Used to change the VLAN type to port_based
VLAN on the Switch.
Syntax disable 802.1q_based vlan
Description
This command allows you to change the VLAN
type to port_based VLAN on the Switch.
Parameters
None.
Example usage:
To switched the VLAN type to Port_based VLAN
Figure 73. disable 802.1q_based vlan command
config pvid
Purpose
Used to configure the 802.1Q Port VLAN ID and
priority.
Syntax config pvid <portlist> <vlanid 1~4094> priority
<0~7>
Description
This command allows you to configure the
802.1Q Port VLAN ID and priority.
Parameters <portlist> - A port or range of ports to configure
to the specified PVID.
<vlanid 1~4094> - To configure the 802.1Q