89
disable stp
Purpose
Used to disable STP on the Switch.
Syntax disable stp
Description
This command allows the Spanning Tree
Protocol to be disabled on the Switch.
Parameters
None.
Example usage:
To disable STP on the Switch:
Figure 83. disable stp command
config stp
Purpose
Used to setup STP on the Switch.
Syntax
config stp {maxage <value 6-40> | hellotime <value
1-10> | forwarddelay <4-30> | priority <value 1-
65535> | fbpdu [enable | disable]}
Description
This command is used to setup the Spanning Tree
Protocol (STP) for the entire Switch.
Parameters
maxage <value 6-40> - The value may be set to ensure
that old information does not endlessly circulate through
redundant paths in the network, preventing the effective
propagation of the new information. Set by the Root
Bridge, this value will aid in determining that the Switch
has spanning tree configuration values consistent with
other
To Next Page
Loading...
