DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 - 5.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
•
•
•
Ethernet instructs the Switch to examine the layer 2 part of each packet
header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source IP
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP
Destination IP Address- Enter an IP Address mask for the destination IP address.
Port
The Access Rule may be configured on a per-port basis by entering the port number of
the Switch into this field. Entering all will denote all ports on the Switch.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following
screen:
Figure 9- 12. CPU Interface Filtering Rule Display - IP
The following window is the CPU Interface Filtering Rule Table for Packet Content.
111
To Next Page
Loading...
