DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Reauthenticate Port(s) for Port Based 802.1x
This window allows you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull
down menus From and To and clicking Apply. The Reauthenticate Port Table displays the current status of the
reauthenticated port(s) once you have clicked Apply.
Click Security > 802.1X > Reauthenticate Port(s) to view the following window:
Figure 10- 18. Reauthenticate Port and Reauthenticate Port Table window
This window displays the following information:
Parameter Description
Port
The port number of the reauthenticated port.
MAC Address
Displays the physical address of the Switch where the port resides.
Auth PAE State
The Authenticator State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth or ForceUnauth.
BackendState
The Backend State will display one of the following: Request, Response, Success, Fail,
Timeout, Idle or Initialize.
Open Dir
The Operational Controlled Directions are both and in.
PortStatus
The status of the controlled port can be Authorized or Unauthorized.
NOTE: The user must first globally enable 802.1X in the DES-3018 Web Management Tool
window before reauthenticating ports. Information in the Reauthenticate Ports Table cannot be
viewed before enabling 802.1X.
NOTE: The uplink module ports (DES-3010F/G ports 9-10, DES-3018 ports 17-18, DES-3026
ports 25-26) do not support the 802.1X function.
129
To Next Page
Loading...
