DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Figure 10- 22. Current Traffic Segmentation Table
Click on the Setup button to open the Setup Forwarding ports page, as shown below.
Figure 10- 23. Setup Forwarding Ports window
This page allows you to determine which port on a given switch in a switch stack will be allowed to forward packets to
other ports on that switch.
Configuring traffic segmentation on the Switch is accomplished in two parts. First, you specify a port from that switch,
using the Port pull-down menu. Then specify the different ports that you want to be able to receive packets from the port
you specified in the first part.
Clicking the Apply button will enter the combination of transmitting port and allowed receiving ports into the Switch’s
Traffic Segmentation table.
The Port drop-down menu allows you to select a port from that switch. This is the port that will be transmitting packets.
The Forward Port click boxes allow you to select which of the ports on the selected switch will be able to forward
packets. These ports will be allowed to receive packets from the port specified above.
Click Apply to enter the settings into the Switch’s Traffic Segmentation table.
133
To Next Page
Loading...
